Quasar CM-3211 Series Manual de instalación descargar pdf (Pagina 20)

CCM-3211 Series Installation Manual

2.) Thread the power and Ethernet cables and any other wires (such as a relay

output, alarm input, audio in, or audio out) through the wire entry. If you are not

wiring from within the wall, you can run the wires through the cable entry hole on

the side of the dome. If needed, you may need to unscrew the disk from the cable

entry hole and screw it into the alternate unused conduit cable entry hole in order

to seal it.

Tip: Even if you are not using alarm inputs and audio input/output at the time of

installation, you may want to consider pre-wiring these connections for future use.

NOTE: The power cable is not required if using PoE.

3.) Thread the wires through the base and screw it to the predrilled wall, ceiling, CM

Series Mini Dome Recessed Mount, CM Series Mini Dome Corner Mount, or 4S

electrical box. Check that the installation is not flimsy, will not wobble, and is flush

with the mounting surface.

Tip: Use shims for shoring up mounts on uneven surfaces.

4.) Snap the camera module back on the base with the wiring threaded through the

gap at the module base and then screw in the module-fastening screw.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 146 147

Sin comentarios

Quasar CM-3211 Series Manual de instalación Pagina 20