Quasar CM-3211 Series Manual de instalación descargar pdf (Pagina 14)

CCM-3211 Series Installation Manual

4.4 Initial Camera Configuration

To perform the initial camera configuration:

1.) Using the supplied star-bit tool, unscrew the mini-dome cover, and remove it.

2.) Plug the CAT5 cable into the camera’s Ethernet port. If the network doesn’t

provide PoE 802.3af, wire a properly rated 12VDC/24VAC power supply into the

terminal-block plug and plug it into the power terminals. See polarity noted in HD

Series Connections image.

3.) Do one of the following:

 Copy and run the DeviceSearch.exe from the included CD.

 From the Latitude Sidebar, run the Unified Configurator by selecting

Applications  Device Configuration Tool and then on the Unified

Configurator screen, click DVTel HD Series.

4.) In the DeviceSearch application, click Device Search and do the following:

a.) In the search results, click on the camera to select it.

b.) Right-click and select from the shortcut menu Network Setup.

c.) In the dialog that appears, select Static IP.

d.) Enter the IP Address, Gateway and Netmask (network mask) as needed

and click OK.

5.) Disconnect the Ethernet cable and, if you are using a power supply, turn off the

power to the power supply and unplug it. The camera is ready for deployment in a

site installation (mounting).

Note: The camera can be connected to a PC for bench installation via an Ethernet

cross-cable.

Note: The camera default IP Address is 192.168.0.250 and default subnet mask is

255.255.255.0.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 146 147

Sin comentarios

Quasar CM-3211 Series Manual de instalación Pagina 14