Quasar CM-3211 Series Manual de instalación descargar pdf (Pagina 13)

CCM-3211 Series Installation Manual

Adjusting and Framing Up the Camera View

4.3 Power and Ethernet Cable Connection

Power Connection

Make sure the camera’s power cable is properly connected. Refer to the pin definition table in

Camera Connectors. If using Power over Ethernet (PoE), make sure Power Sourcing

Equipment (PSE) is available on the connected network. All electrical work must be

performed in accordance with local regulatory requirements.

Ethernet Cable Connection

Use of Category 5 Ethernet cable is recommended for network connection. For best

transmission quality, cable length should not exceed 100 meters (328 feet). Connect one

end of the Ethernet cable to the RJ-45 connector of the CM-3211-xx camera and the other

end to the network switch or PC.

NOTE: You can use an Ethernet crossover cable to connect the CM-3211-xx directly

to a PC.

Check the status of the link indicator and activity indicator LEDs. If the LEDs are unlit, check

the LAN connection.

The green Link LED indicates a good network connection.

The orange Activity LED flashes to indicate network activity.

AUTO

IRIS

1 2 3 4

I/O

NETWORK

DC12V

LINE

LINE IN

MIC IN

OUT

VIDEO

RESET

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 146 147

Sin comentarios

Quasar CM-3211 Series Manual de instalación Pagina 13