Quasar CM-3211 Series Manual de instalación descargar pdf (Pagina 17)

CCM-3211 Series Installation Manual

achieved when the system is assembled.

b.) In the marked locations, drill each hole using a drill-bit of a slightly smaller

diameter than the supplied screw anchors (molly-plug anchor). You want to

achieve a snug insertion so that the plug expansion holds firm after the screws

are screwed in.

c.) Fully insert the supplied anchors into drilled holes. You may need to tap them

flush with the wall using a finishing hammer.

 For installing on a 4S recessed electrical box:

a.) Have a qualified installer (check your local electrical codes) rough-in the 4S

recessed electrical box and run the wires and power (if not PoE) through the

wall/conduits to the box location.

b.) Ensure that the box is sufficiently sturdy (attach to the wall stud, ceiling joist,

or reinforced surface as needed) to securely hold the weight of the camera.

 For bracket, pole and pendant installations:

o Follow the hanging device installation instructions.

2.) If running the cables through the back, thread the power and Ethernet cables and

any other wires (such as a relay output, alarm input, audio in, or audio out)

through the back wire entry. If you are not wiring from within the wall, you can

run the wires through the slot on the side of the mini-dome. Punch out the half

circle slot and run the wires through this slot.

Tip: Even if you are not using alarm inputs and audio input/output at the time of

installation, you may want to consider pre-wiring these connections for future use.

NOTE: The power cable is not required if using PoE.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 146 147

Sin comentarios

Quasar CM-3211 Series Manual de instalación Pagina 17