Quasar CM-3211 Series Manual de instalación descargar pdf (Pagina 19)

CCM-3211 Series Installation Manual

Note: Do not reassemble the camera’s inner cover and mini-dome cover until after

hardware configurations and lens adjustments are made.

4.6.3 Mounting the CM-3211-01, CM-3211-11, or CM-3211-

11-I Outdoor Camera

1.) Do one of the following:

 For drilled wall or ceiling mounting:

a.) Use a pointed pencil and the base as a template to mark the mounting surface

through the plate holes where the four screw holes need to be drilled.

Important: Before marking and drilling the holes, ensure that the base plate

alignment is oriented correctly so that the required camera field of view can be

achieved when the system is assembled.

b.) In the marked locations, drill each hole using a drill-bit of a slightly smaller

diameter than the supplied screw anchors (molly-plug anchor). You want to

achieve a snug insertion so that the plug expansion holds firm after the screws

are screwed in.

c.) Fully insert the supplied anchors into drilled holes. You may need to tap them

flush with the wall using a finishing hammer.

 For installing on a 4S recessed electrical box:

a.) Have a qualified installer (check your local electrical codes) rough-in the 4S

recessed electrical box and run the wires and power (if not PoE) through the

wall/conduits to the box location.

b.) Ensure that the box is sufficiently sturdy (attach to the wall stud, ceiling joist,

or reinforced surface as needed) to securely hold the weight of the camera.

 For bracket, pole and pendant installations:

o Follow the hanging device installation instructions.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 146 147

Sin comentarios

Quasar CM-3211 Series Manual de instalación Pagina 19