Quasar CM-3211 Series Guía de instalación descargar pdf (Pagina 75)

Quasar CM-3211/CM-4221 Series User and Installation Guide

Triggered Action

The Administrator can specify various alarm actions to be taken when an alarm is triggered. The

options are listed below.

 Enable alarm output – Check this box and select the predefined type of alarm output (low or

high) to enable alarm relay when tampering is detected.

 Record stream to sd card -– Select this box in order to save the alarm-triggered recording

into a microSD/SDHC card. Enter the number of seconds for the pre-trigger buffer. Select the

first radial button to upload for a specified length of time and enter the number of seconds.

Alternatively, select the second radial button to upload during the active trigger. See Figure

53: Application – Record Stream to SD Card.

Note:

Make sure that local recording (with a microSD/SDHC card) is activated so that this

function can be implemented. See Recording for further details.

 Send message by FTP/E-Mail – Select whether to send an alarm message by FTP and/or

e-mail when a network failure is detected.

Save

Click Save to save the network failure detection settings.

7.3.11 Tampering

The tampering alarm function helps the IP camera deal with tampering (such as, deliberate

redirection, blocking, paint-spraying, and obscuring the lens, etc.). Using video analysis, the camera

can react to such events by sending out notifications or uploading snapshots to the specified

destination(s).

Figure 60: Tampering Alarm Screen

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 136 137

Sin comentarios

Quasar CM-3211 Series Guía de instalación Pagina 75